Entering The System Service Tag Using Intel Active Management Technology - Dell PowerEdge T30 Owner's Manual

Figure 51. Installing the system board
Next steps
1 Install the following:
a heat sink and processor
b memory modules
c expansion cards
d system fan
2 Connect all cables to the system board.
3 Follow the procedure listed in the After working inside your system section.
4 Enter the system service tag after you install the system board. For more information about entering the service tag, see the
Entering The Service Tag After Replacing The System Board section.
Related links
Before working inside your system
Installing a heat sink
Installing a processor
Installing a memory module
Installing an expansion card
Installing the system fan
After working inside your system
Entering the system service tag using Intel Active
Management Technology
Prerequisites
NOTE: Intel Active Management Technology (AMT) is supported only on Intel Xeon processor-based systems.
This procedure is used to update the service tag after a system board replacement.
Steps
1 Remove the system cover.
Installing and removing system components 89