Hardware Assembly - Flashforge Finder User Manual

1.3 Hardware Assembly

Your Finder has been installed before leaving factory, you can start up the
Finder for printing after mounting the filament spool and completing
leveling..
Installing the Filament
1. Remove the filament cartridge in
the rear of Finder, where you will
place the filament spool.
2. Thread the filament through the
filament guide tube.
Note: You should ensure the filament
spool rolls anticlockwise.
3. Put the filament cartridge back to
the Finder. Next you can load the
PLA filament to the extruder.
Finder User Guide| www.ff3dp.com
13