Chapter 1. Set Up Your Finder; Unpacking Your Finder - Flashforge Finder User Manual

Chapter 1. Set up Your Finder

1.1.Unpacking Your Finder

We are so grateful for your support to Flashforge by purchasing Finder
3D printer and so excited to start the print journey with us. After
15-minute reading and learning, we believe you can making your first 3D
object definitely on your own. When you set up your Finder 3D printer,
remember that it was built and packaged carefully at the Flashforge
Factory. We hope you will take your time and be just as carefully
unpacking and getting setup. Let's get started!
1. Place the packaging box on a
clean work surface. Open the box,
grasp the two handles and then lift
your Finder out of the box.
2. Your Finder is wrapped by
packaging material.
should remove
material.
Finder User Guide| www.ff3dp.com
Next, you
the packaging
6