Calibration And Verification - jenway Genova Nano Operating Manual

4. Select the digit to be changed using the keys at the bottom of the screen. Use the keys adjacent
to the Arrow icons to increase or decrease the number. Press the key adjacent to the Tick icon
to save any changes.
7.2.3

Calibration and Verification

If an error message is displayed during the calibration and verification procedure, refer to
Section 11 for further details.
2. The Air Measurement icon will be displayed. If a USB stick is inserted into the unit, a Save icon
will also be displayed.
20
2. Select the digit to be changed using the keys at
the bottom of the screen. Use the keys adjacent
to the Arrow icons to increase or decrease the
number. Press the key adjacent to the Tick icon
to save any changes.
3. Enter the stated path length in mm (1.0mm for
the supplied calibration standard solution set)
for the DNA standard solution into the accessory
settings by pressing the key adjacent to the
Calibration Standard Path Length Value icon.
1. The calibration sequence is initiated by pressing
the key adjacent to the Path Length Calibration icon.