Mechanical Disassembly; Mechanical Disassembly Flow Chart - Eiki LC-HDT1000 Service Manual

Mechanical Disassembly

Mechanical disassembly flow chart

Mechanical disassembly should be made by following procedures chart.
Following steps show the basic procedures, therefore unnecessary step may
be ignored.
Caution:
The parts and screws should be placed exactly the same position as the origi-
nal otherwise it may cause loss of performance and product safety.
The wiring method of the leads and ferrite cores should be returned exactly the
same state as the original, otherwise it may cause lose of performance and
product safety.
1 cabinet front cover removal
2 cabinet front removal
3 cabinet top removal
4 Main board removal
5 Filter holder assy removal
6 shutter assy, motor, lens-net and rc rear bards removal
7 ex sensor, rgB fan-net, lamp fan-net, illumi boards removal
8 side panel assy removal
9 Power box assy removal
10 Lens shift assy removal
11 optical unit removal
12 optical lamp unit removal
13 Lens cover holder and ac inlet assy removal
14 duct cover assy removal
2-1 Led and rc front board removal
3-1 Lamp cover removal
3-2 Filter cover removal
5-1 Filter holder disassembly
5-2 Filter motor assy disassembly
8-1 side panel assy disassembly-1
8-2 side panel assy disassembly-2
8-3 aV assy disassembly
9-1 Power box assy removal-1
9-2 Power box assy disassembly-1
9-3 Power box assy disassembly-2
10-1 Lens shift assy disassembly
12-1 Lamp id iF board and Fans removal
13-1 ac inlet assy disassembly
13-2 Wiring of the ac inlet assy
14-1 duct cover assy disassembly
-22-
Screws Expression
(Type ) mm
Diameter x Length
T type M Type