Mechanical Disassembly - Eiki LC-WB200 Service Manual

Mechanical Disassembly

Mechanical disassembly should be made following procedures in numerical or-
der.
Following steps show the basic procedures, therefore unnecessary step may
be ignored.
Caution:
The parts and screws should be placed exactly the same position as the original
otherwise it may cause loss of performance and product safety.
1. Filter cover (side), Cabinet Top, Front, RC Board removal
1. Pull up two Latches to take off the Filter cover(side).
. Loosen 1 screw-A to remove the Lamp Cover.
3. Remove 6 screws-B (M3x8) and 1 screw C-(M3x8) to remove the Cabinet Top.
4. Remove 4 screws-D (M3x8) and 3 screws-E (T3x8) to remove the Cabinet Front.
5. Remove  screws-F(T3x8) to remove the RC board.
RC Board
D
D
E
Dec Inlay LED
Control Buttons
Filter cover(side)
Latches
F(T3x8)x
F
D
D
E
E
Cabinet top
B
B
Cabinet Front
-13-
Screws Expression
(Type
Diameter x Length
T type
Lamp Cover
B
A
C
B
B
B
) mm
M Type
Fig.1