Table of Contents
Advertisement
6) Secure the servo to the aileron hatch
using Phillips screwdriver and the screws
provided with the servo.
7) Apply 1-2 drops of thin C/A to each of
the mounting tabs. Allow the C/A to cure
without using accelerator.
C/A glue
8) A string has been provided in the wing
to pull the aileron lead through to the
wing root. Remove the string from the
wing at the servo location and use the
tape to attach it to the servo extension
lead. Pull the lead through the wing and
remove the string.
WWW.SEAGULLMODELS.COM
9) Set the aileron hatch in place and use a
Phillips screw driver to install it with four
wood screws.
2x10mm
.
13
Advertisement
Table of Contents
