Replace The Cf Card And Do Not Retain The Customers Recordings - NEC XN120 Getting Started Manual

Replace the CF card and do not retain the customers recordings

This method will not keep any of the customers recorded messages.
1 Power off the XN120 system
2 Remove the Version 1
Compact Flash card from the
DSPDB card.
3 Fit the Version 2 Compact
Flash card into the DSPDB
card
4 Power on the XN120 system
DSPDB Multi Language Guide
You must also power off each XN120 expansion unit if you have any
installed.
The card pulls out; there are no retaining clips.
The card pushes in; there are no retaining clips.
If you have any expansion units installed you must power these on
first.
The DSPDB card will be configured automatically.
! System Start Up – Retain Customer Configuration
This is the normal operation for powering the XN120 on.
Before you power on the system check that the NORMAL switch is set
to ON. This will ensure that the system memory retains your
configuration.
The NORMAL switch is located to the right of the MOH/Page
connector on the main unit; refer to the Getting Started Guide supplied
with the XN120 for further information.
Upgrading the DSPDB Card
7