Setting Of Bearing Pulses From Antenna (Output Pulse) - JRC JMA-5912-6 Instruction Manual

[II] TNI Blank Area Creation (Make Sector)
Procedures 1. Transmit the radar.
2. Open the Serviceman Menu.
3. Open the TNI Blank menu by performing the following menu
operation.
4. Press the
5. Set the starting bearing of the TNI blank by operating the [EBL] dial,
and press the [ENT] key.
6. Set the ending bearing of the TNI blank by operating the [EBL] dial,
and press the [ENT] key.
7.2.4

Setting of Bearing Pulses from Antenna (Output Pulse)

Set the output value of bearing pulses from the antenna. The system can set 2048 pulses or 4096 pulses.
This setting is enabled only when an antenna of 25 or 30 kW is used.
Procedures 1. Open the Serviceman Menu.
2. Open the Output Pulse menu by performing the following menu
operation.
3. Set the number of pulses to be output by the antenna.
* If a 10 kW antenna is used, 2048
2. Installation Menu
→ 9. Next
→ 2. TNI Blank
2. Make Sector
1. Adjust Menu
→ 4. TXRX Adjustment
→ 6. Output Pulse
2048 : 2048 pulses per antenna rotation (Recommended value)
4096 : 4096 pulses per antenna rotation
7-16
button in the menu.
is always set.
7.2 Settings
7