JRC JMA-5912-6 Instruction Manual page 139

Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the Mode menu.
2. Select the satellite or the beacon whose differential information is
used.
Beacon
SBAS
AUTO
3. Press the [6] key to send the setting value to SBAS receiver.
[Ⅱ] Ranging satellite setting (Ranging)
Set the SBAS satellite to be used or not to be used.
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the SBAS Setting menu.
2. Press [2] key to select the SBAS satellite to be used or not to be
used.
On
Off
3. Press the [6] key to send the setting value to SBAS receiver.
[Ⅲ] Prohibitive satellite setting (NG SBAS)
Set the information from prohibitive SBAS satellite to be used or not to be used.
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the SBAS Setting menu.
2. Press [3] key to select the information from prohibitive SBAS satellite
to be used or not to be used.
On
Off
3. Press the [6] key to send the setting value to SBAS receiver.
4. NAV equipment Setting
→ 4. GPS Setting
→ 3. SBAS Setting
→ 1. Mode
: SBAS receiver use the information from beacon
: SBAS receiver use the information from SBAS satellite
: SBAS receiver selects automatically
4. NAV equipment Setting
→ 4. GPS Setting
→ 3. SBAS Setting
: SBAS satellite is used
: SBAS satellite is not used
4. NAV equipment Setting
→ 4. GPS Setting
→ 3. SBAS Setting
: The information from prohibitive SBAS satellite is used
: The information from prohibitive SBAS satellite is not used
3-44
3.4 General Radar Operation
3