Sector Blank Setting (Sector Blank) - JRC JMA-5912-6 Instruction Manual

[V] GPS Receive Port Setting (Select NAV Equipment)
Select the receive port of GPS data.
Procedures 1. Open the Serviceman Menu.
2. Open the COM Port setting menu by performing the following menu
operation.
3. Press the [5] key.
Units of Select NAV Equipment are switched.
7.2.2

Sector Blank Setting (Sector Blank)

In order not to display radar echoes, set a sector and stop transmission in the bearing. Three sector blank
areas can be created.
The sector blank function operates in the relative bearing with the bow.
[I] Sector Blank Function On/Off (Sectors 1, 2, and 3)
Procedures 1. Open the Serviceman Menu.
2. Open the Sector Blank menu by performing the following menu
operation.
3. Set the sector blank number
sector blank function operates.
The system allows the use of up to three sector blank areas.
Set each sector blank area to on or off.
2. Installation Menu
→ 5. COM Port Setting
Internal GPS : The receive port is selected GPS connector of processor unit
(JRC's GPS).
External GPS : The receive port is selected GPS terminal of terminal board
circuit.
2. Installation Menu
→ 3. Sector Blank
On : The sector blank function is operated.
Off : The sector blank function is stopped.
7-14
Sector 1 , 2 , or 3 with which the
7.2 Settings
7