JRC JMA-5912-6 Instruction Manual page 140

[Ⅳ] Satellite number select mode setting (SBAS Select Mode)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Press [4] key to select the satellite number select mode.
3. Press the [6] key to send the setting value to SBAS receiver.
[Ⅴ] Satellite number setting (SBAS No.)
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
2. Enter the satellite number.
3. Press the [6] key to send the setting value to SBAS receiver.
Set the satellite number select mode.
menu open procedure to open the SBAS Setting menu.
4. NAV equipment Setting
→ 4. GPS Setting
Manual : SBAS satellite number is set manually
AUTO : SBAS satellite number is set automatically
Set the satellite number.
This setting is enabled when satellite number select mode is set to manual.
menu open procedure to open the SBAS No. menu.
4. NAV equipment Setting
→ 4. GPS Setting
Enter the number from 120 to 138.
→ 3. SBAS Setting
→ 3. SBAS Setting
→ 5. SBAS No.
3-45