Most Frequent Mounting Errors - 2N Helios IP Vario Installation Manual

2.4 Completion
Remember to seal the
1.
moisture in-leak and damage to electronics due to condensation.
Make sure that the wires inside
2.
the plastic top cover (a transparent plastic mould) carefully making its contacts
plug into the electronics board connectors. Push the plastic cover into position
moderately. If the part swings over an obstacle or one corner is higher than the
others, remove the cover and find the obstacle. Then tighten the corner screws
properly.
Mounting the metal sheet cover follow the steps included in the subsection
3.
dedicated to name plate removal. Make sure that the cover fits well and is
perfectly flat. If its bottom part is loose, the mounting wall is probably uneven.
Support the corners to avoid
Caution
An improper mounting may significantly deteriorate the button function.
A poor outdoor mounting may cause water in-leak and damage to the
electronics.

Most Frequent Mounting Errors

For illustration, a part of the plastic cover is removed in the figures below to reveal the
sealed loudspeaker and the cover-seal touch point. The cross section plane is marked
white for better orientation.
2N TELEKOMUNIKACE a.s., www.2n.cz
®
2N Helios IP Vario
®
2N Helios IP Vario
®
2N Helios IP Vario
cable passage hole properly to avoid
are not squeezed and insert
bending.
52/97