Table of Contents
Advertisement
3 SPECIFICATIONS
3.2.13 Q64TC control status controlling output signal and buffer memory settings and control
status
Setting/operation
PID continuation flag
mode command
(refer to Section 3.5.41)
(refer to Section 3.4)
Yn1, Xn1
1)
Setting mode
(at power-on)
2)
Operation mode
(during operation)
3)
Setting mode
(after operation)
: The settings of the setting/operation mode command will be explained in the following three different modes.
Setting/operation
mode command
3 - 20
The Q64TC has the output signals (Y), buffer memory and intelligent function module
switch which set its control status.
The control status of the Q64TC is governed as indicated below by the settings of the
output signals, buffer memory and intelligent function module switch.
(1) Intelligent function module switch setting
Output setting for CPU stop error (refer to Section 4.5)
Intelligent function module switch
If a CPU stop error occurs at the setting of "CLEAR"
(2) Unused channel setting
Unused channel setting (refer to Section 3.5.33)
(3) Other settings
Forced PID control
stop command
(refer to Section 3.4.3)
A9
YnC to YnF
H
Stop/continue
Stop/continue
Stop
Continue
ON
OFF
1) Setting mode
Other than above
3D
, 5D
, 7D
, 9D
H
H
H
H
Unused
Used
Stop mode setting
(refer to Section 3.5.13)
21
, 41
H
Stop
OFF/ON
Monitor
Alert
OFF
Stop/monitor/alert
Stop
ON
Monitor
Alert
Stop
OFF/ON
Monitor
Alert
OFF
Stop/monitor/alert
Stop
ON
Monitor
Alert
2) Operation
mode
Control status
Temperature
PID control
—
In accordance with control
status of other setting items
: Executed, —: Not executed
Control status
Temperature
PID control
—
In accordance with control
status of other setting items
: Executed, —: Not executed
Control status
Temperature
PID control
, 61
, 81
H
H
H
—
—
—
—
—
—
—
—
—
—
—
—
: Executed, —: Not executed
3) Setting mode
MELSEC-Q
Alert
judgment
judgment
—
—
Alert
judgment
judgment
—
—
Alert
judgment
judgment
—
—
—
—
—
—
—
—
—
—
—
—
3 - 20
Advertisement
Table of Contents
