Program Example Written Using Gx Configurator-Tc; Gx Configurator-Tc Operation - Mitsubishi Electric MELSECSystem Q User Manual

6 PROGRAMMING

6.2 Program Example Written Using GX Configurator-TC

6.2.1 GX Configurator-TC operation

Setting item
CH1 input range
CH1 set value setting (SV)
CH1 warning1 mode setting
CH1 warning set value 1
CH1 upper limit setting limiter
CH1 lower limit setting limiter
CH2 unused channel setting
CH3 unused channel setting
CH4 unused channel setting
Setting item
Data write error code
CH1 measured temperature
value(PV)
6 - 3
(1) Initial setting (Refer to Section 5.4)
Make setting as indicated below.
Set the input range of CH.1.
Set the set value of CH.1.
Set the alert 1 mode of CH.1.
Set the alert set value 1 of CH.1.
Set the upper setting limiter of CH.1.
Set the lower setting limiter of CH.1.
Choose whether CH.2 is used or unused.
Choose whether CH.3 is used or unused.
Choose whether CH.4 is used or unused.
(2) Automatic refresh setting (Refer to Section 5.5)
Make setting as indicated below.
Set the device where the write data error code will be stored.
Set the device where the temperature process value of CH.1 will be
stored.
(3) Intelligent function module parameter write (Refer to Section 5.3.3)
Write the parameter values of the intelligent function module to the PLC CPU.
Perform this operation on the parameter setting unit selection screen.
Description
Description
MELSEC-Q
Setting
2
200
Upper limit input
500
400
0
Unused
Unused
Unused
Setting
D50
D51
6 - 3