Installing And Uninstalling The Utility Package; User Precautions - Mitsubishi Electric MELSECSystem Q User Manual

Q64tctt;q64tcttbw; q64tcrt;q64tcrtbw

Table of Contents

5 UTILITY PACKAGE (GX Configurator-TC)

5.2 Installing and Uninstalling the Utility Package

5 - 3

See "Method of installing the MELSOFT Series" attached with the utility package

regarding the install and uninstall operation for the utility package.

The following explains the precautions on using the Utility package:

(1) Important safety information

Since the utility is add-in software for GX Developer, make sure to read "Safety

Precautions" and the basic operating procedures in the GX Developer Operating

Manual.

(2) About installation

GX Configurator-TC is an add-in software package for GX Developer Version 4

or later products. Therefore, install GX Configurator-TC in a personal computer in

which GX Developer Version 4 or later product has been installed.

(3) About display screen errors while using the intelligent function

module utility

There may be cases in which the screen will not properly display while the

intelligent function module utility is being used, due to a lack of system resources.

If this occurs, close the intelligent function module utility first, and then close GX

Developer (program, comments, etc.) and other applications. Next, restart GX

Developer and the intelligent function module utility.

(4) To start the intelligent function module utility

(a) In GX Developer, select "QCPU (Q mode)" for the PLC series and specify the

project. If anything other than "QCPU (Q mode)" is selected for the PLC

series, or if no project is specified, the intelligent function module utility will not

start.

(b) Multiple intelligent function module utilities can be started.

However, the [Open file]/[Save file] parameter operations of the intelligent

function module can only be performed by a single intelligent function

module utility. Other intelligent function module utilities can perform the

[Monitor/test] operation only.

(5) How to switch screens when two or more intelligent function

module utilities are started

When two or more intelligent function module utility screens cannot be displayed

side by side, use the task bar to display the desired intelligent function module

utility screen on top of other screens.

MELSEC-Q

5 - 3

Table of Contents