Table of Contents
Advertisement
[M]
MAN mode shift completion flag................... 3-33
MAN output setting........................................ 3-41
Ind.
Manipulated value ................................3-32, 3-46
Manipulated value resolution switching........ 3-46
Measured temperature range ........................ 3- 3
Module ready flag.......................................... 3-23
[O]
Outline module change .................................. 7- 1
Output off-time current error
detection function ........................................ 3-12
Output variation limiter setting ...................... 3-38
[P]
Parts identification .......................................... 4- 3
PID action ...................................................... 1-11
PID constant setting ...................................... 3-37
PID continuation flag ..................................... 3-45
PID control system ......................................... 1- 5
PID operation.................................................. 1- 6
Primary delay digital filter setting .................. 3-39
Procedure before starting the operation........ 4- 2
Programming.................................................. 6- 1
Proportional action (P-action) ........................ 1- 8
[R]
Reference heater current value .................... 3-48
Reverse action/forward
action selection function............................... 3- 9
RFD limiter function........................................ 3- 9
[S]
Sampling period ............................................ 3-21
Sensor compensation function ...................... 3- 9
Sensor compensation value setting.............. 3-38
Set value (SV) setting ................................... 3-37
Setting change command ............................. 3-27
Setting change completion flag..................... 3-25
Setting change rate limiter setting ................ 3-41
Setting mode/operation mode command ..... 3-26
Stop mode setting ......................................... 3-36
System configuration...................................... 2- 1
Index - 2
[T]
Temperature process value...........................3-31
Temperature rise completion range setting ..3-45
Temperature rise completion
soak time setting ..........................................3-45
Temperature rise judgment flag ....................3-32
Temperature sensor type ...............................3- 3
Three-phase heater .......................................4-11
Transistor ON delay output
delay time setting .........................................3-45
Transistor output flag .....................................3-32
Troubleshooting ..............................................8- 1
[U]
Unused channel setting ....................... 3-10, 3-43
Upper/lower output limiter setting..................3-37
Upper/lower setting limiter .............................3-42
Utility package.................................................5- 1
[W]
Wiring precautions ..........................................4- 6
Write data error code .....................................3-30
Write error flag ...............................................3-23
Index - 2
Advertisement
Table of Contents
