3 Electrical Requirements; 4 Unpacking The System; 5 System Installation; 6 Power Cord Connection - DENTSPLY Cavitron JET Plus Installation And Service Manual

7 3 Electrical Requirements

• Incoming power to the system must be 100 volts AC to
240 volts AC, single phase 50/60 Hz capable of
supplying 1.0 amps.
• The system power should be supplied through the AC
power cord provided with your system.

7 4 unpacking the System

Carefully unpack your Cavitron
and verify that all components and accessories are included:
1. Cavitron JET Plus Combination System with
®
Handpiece Cable Assembly with swivel
2. Air Line Assembly (Black) with Filter and Quick
Disconnect
3. Water Line Assembly (Blue) with Filter and Quick
Disconnect
4. Additional Water Line Filter
5. Detachable AC Power Cord (not shown)
6. Cavitron Tap-On
® TM
7. "AA" Batteries (4-Pack)
8. Auxiliary Cable for Tap-On
9. Cavitron JET Air Polishing Insert with cleaning tool
®
10. JET-Mate Detachable Sterilizable Handpiece
11. Prophy Handpiece Cleaning Wire (not shown)
12. Cavitron Ultrasonic Inserts (quantity optional)
®
13. Efficiency Indicator for Cavitron Inserts
14. Literature Packet
15. PROPHY-JET Sodium Bicarbonate Prophy Powder
®
16. JET-Fresh Aluminum Trihydroxide Prophy Powder
®
(may not be included in all kits)
17. Powder Removal Container

7 5 System installation

• The Cavitron JET Plus Combination System is designed
®
to rest on a level surface. Be sure unit is stable and
resting on four feet.
• Placing unit in direct sunlight may discolor plastic
housing.
• The system has been equipped with a Cavitron
Wireless Foot Pedal which was factory synchronized
to operate with the system's base unit. If your office
JET Plus Combination System
®
Wireless Foot Pedal
Foot Pedal
TM
Tap-On
®
has more than one Cavitron
recommended that you mark the Tap-On
and base unit for easy reference as to which Tap-On
Foot Pedal operates with which base unit. Should
resynchronization be necessary, follow the instructions in
Section 7.10.

7 6 Power Cord Connection

• Verify the Main Power ON/OFF switch, located at the
center front underside of the System, is set to the OFF
(O) position before proceeding.
• Insert the AC power cord into the power input on the
back of the System.
• Insert the pronged plug into an AC wall outlet.

7 7 water Supply Line Connection

• Grasp the Water Supply Line (blue hose) by the end
opposite the quick-disconnect and insert it into the water
inlet connector until fully seated.
• Connect the quick-disconnect to the dental office water
supply or a Cavitron DualSelect Dispensing System.
• Inspect all connections to make certain there are no
leaks.
• To remove the water line from the Cavitron
Combination System, turn off the dental office water
supply. Disconnect the water supply line from the dental
TM
office water supply. If a quick-disconnect connector is
attached to the end of the hose, relieve the water
9
JET Plus system, it is
®
Foot Pedal
TM
TM
JET Plus
®