9.19 VErticAl stAbiliZEr ArM rEPlAcEMEnt
1) Remove the bolt that holds the vertical stabilizer arm to the frame (Figures A & B).
figUrE A
2) Remove the bolt from the upper pivot joint of the vertical stabilizer arm (Figure C).
3) Remove the vertical stabilizer arm (Figure D).
figUrE c
4) Reverse Steps 1-3 to install a vertical stabilizer arm. note: Tighten the bolt removed in Step 2 to 80 N-m torque.
5) Test the Ascent Trainer for function as outlined in Section 9.22.
cHAPtEr 9: PArt rEPlAcEMEnt gUidE
figUrE b
figUrE d
77