Touch Screen Care & Cleaning; Auto Calibration Instructions - Matrix Fitness A7xE-04 Ascent Trainer Service Manual

cHAPtEr 3: PrEVEntAtiVE MAintEnAncE
3.4 toUcH scrEEn cArE & clEAning
* The touch screen requires very little maintenance. We recommend that you periodically clean the touch screen surface with a clean dry 100%
lint free cloth and water / soap mixture or a computer or LCD / LED screen cleaner.
* It is very important to avoid using any other chemical on the touch screen.
* Always dampen the cloth and clean the screen. Do not spray the water / soap mixture on the screen itself, the drips can seep into the display
or stain the bezel.
* After cleaning, make sure the surface is dry. There should not be any left over solvent to seep into the display.
* It is very important to handle the touch screen with care. Do not use excessive force when cleaning.
* Do not use any sharp materials to clean the touch screen surfaces.
* Do not use high pressure air, water, or steam to clean the touch screen surface.
3.5 AUto cAlibrAtion ProcEdUrE
After initial installation or replacement of the incline motor, auto calibration should be run.
1) Press ENTER, 2, 0, 0, 1, ENTER on the keypad to go into Engineering Mode.
2) Press CALIBRATION on the display.
3) Press AUTO CALIBRATION on the display.
4) Press START on the display.
5) This will run the Auto Calibration. If the calibration passes, it will say complete. Press the HOME key to return to the normal start screen.
6) If the calibration does not pass, contact Matrix Customer Technical Support at 866-693-4863 ext 3.
toUcH scrEEn cArE And clEAning
AUto cAlibrAtion ProcEdUrE
7