Incline Motor Replacement - Matrix Fitness A7xE-04 Ascent Trainer Service Manual

9.13 inclinE Motor rEPlAcEMEnt

1) Turn off the power and disconnect the cord from the machine.
2) Remove the front disks as outlined in Section 9.1.
3) Complete Steps 6-8 and 10 from Section 9.2 to remove the cup holder and top shrouds from the unit (the main side shrouds do not need to be
removed).
4) Disconnect the incline motor ground wire from the frame and disconnect the incline motor power wire (Figures A & B). If unsure if the incline
motor is the issue, plug in the new incline motor at this time to see if it is energized. If it is not, the issue is likely with the LCB.
figUrE A
5) Remove the spring clip to separate the incline motor from the frame (Figure C).
6) Remove the incline motor by loosening the pivot bolts on each side (Figure D - note: Figure D shows the unit with the shrouds removed for
clarity). NOTE: Prior to loosening the pivot bolts, secure the incline motor as it can fall once the pivot bolts are loosened.
figUrE c
cHAPtEr 9: PArt rEPlAcEMEnt gUidE
figUrE b
figUrE d
69