Dual Action Handlebar Replacement - Matrix Fitness A7xE-04 Ascent Trainer Service Manual

cHAPtEr 9: PArt rEPlAcEMEnt gUidE

9.14 dUAl Action HAndlEbAr rEPlAcEMEnt

1) Remove the plastic cover where the dual action handlebar meets the link arm (Figure A).
2) Remove the bolt and bushings where the dual action handlebar and the link arm meet (Figure B).
figUrE A figUrE b
3) Remove the two bolts that hold on the pivot cap and remove the cap (Figure C).
4) Unplug and separate the heart rate connector exposed once the pivot cap is removed. Then remove the 4 screws that hold the dual action
handlebar to the console mast (Figure D).
figUrE c figUrE d
5) Reverse steps 1-4 to install a new dual action handlebar.
6) Test the Ascent Trainer for function as outlined in Section 9.22.
72