Supported Cards For I/O Identity Optimization - Dell iDRAC 8 User Manual

• View and configure the virtual addresses for network and fibre channel devices (for example, NIC, CNA, FC HBA).
• Configure the initiator (for iSCSI and FCoE) and storage target settings (for iSCSI, FCoE, and FC).
• Specify persistence or clearance of the configured values over a system AC power loss, cold, and warm system resets.
The values configured for virtual addresses, initiator and storage targets may change based on the way the main power is handled
during system reset and whether the NIC, CNA, or FC HBA device has auxiliary power. The persistence of IO identity settings can
be achieved based on the policy setting made using iDRAC.
Only if the I/O identity feature is enabled, the persistence policies take effect. Each time the system resets or powers on, the values
are persisted or cleared based on the policy settings.
NOTE: After the values are cleared, you cannot re-apply the values before running the configuration job.
Related links
Inventorying, monitoring, and configuring network devices

Supported cards for I/O Identity Optimization

Supported NIC firmware versions for I/O Identity Optimization
Enabling or disabling I/O Identity Optimization
Configuring persistence policy settings
Supported cards for I/O Identity Optimization
The following table provides the cards that support the I/O Identity Optimization feature.
Table 30. Supported cards for I/O Identity Optimization
Manufacturer
Broadcom
Intel
Mellanox
Type
• 5720 PCIe 1 GB
• 5719 PCIe 1 GB
• 57810 PCIe 10 GB
• 57810 bNDC 10 GB
• 57800 rNDC 10 GB + 1 GB
• 57840 rNDC 10 GB
• 57840 bNDC 10 GB
• 5720 rNDC 1 GB
• 5719 Mezz 1 GB
• 57810 Mezz 10 GB
• 5720 bNDC 1 GB
• i350 Mezz 1Gb
• x520+i350 rNDC 10Gb+1Gb
• I350 bNDC 1Gb
• x540 PCIe 10Gb
• x520 PCIe 10Gb
• i350 PCIe 1Gb
• x540+i350 rNDC 10Gb+1Gb
• i350 rNDC 1Gb
• x520 bNDC 10Gb
• 40G 2P XL710 QSFP+ rNDC
• ConnectX-3 10G
• ConnectX-3 40G
• ConnectX-3 10G
• ConnectX-3 Pro 10G
• ConnectX-3 Pro 40G
175