Flexelements; Iec 61580 Goose Analog Values - GE UR F35 Series Instruction Manual
Multiple feeder protection
system
Hide thumbs
Also See for UR F35 Series:
- Instruction manual (526 pages) ,
- Instruction manual (616 pages) ,
- Instruction manual (640 pages)
Table of Contents
Advertisement
6 ACTUAL VALUES
PATH: ACTUAL VALUES
METERING
FLEXELEMENT 1
The operating signals for the FlexElements are displayed in pu values using the following definitions of the base units.
Table 6–2: FLEXELEMENT BASE UNITS
DCmA
FAULT LOCATION
FREQUENCY
PHASE ANGLE
POWER FACTOR
RTDs
SOURCE CURRENT
SOURCE ENERGY
(Positive and Negative Watthours,
Positive and Negative Varhours)
SOURCE POWER
SOURCE VOLTAGE
PATH: ACTUAL VALUES
METERING
IEC 61850
GOOSE ANALOGS
MESSAGE
MESSAGE
MESSAGE
The F35 Multiple Feeder Protection System is provided with optional IEC 61850 communications capabil-
ity. This feature is specified as a software option at the time of ordering. Refer to the Ordering section of
chapter 2 for additional details.
The IEC 61850 GGIO3 analog input data points are displayed in this menu. The GGIO3 analog data values are received
via IEC 61850 GOOSE messages sent from other devices.
GE Multilin
FLEXELEMENTS
FLEXELEMENT 1(16)
FLEXELEMENT 1
OpSig: 0.000 pu
BASE = maximum value of the
DCMA INPUT MAX
under the +IN and –IN inputs.
BASE = Line Length as specified in Fault Report
f
= 1 Hz
BASE
ϕ
= 360 degrees (see the UR angle referencing convention)
BASE
PF
= 1.00
BASE
BASE = 100°C
I
= maximum nominal primary RMS value of the +IN and –IN inputs
BASE
E
= 10000 MWh or MVAh, respectively
BASE
P
= maximum value of V
BASE
BASE
V
= maximum nominal primary RMS value of the +IN and –IN inputs
BASE
IEC 61850 GOOSE ANALOGS
ANALOG INPUT
1
0.000
ANALOG INPUT
2
0.000
ANALOG INPUT
3
0.000
↓
ANALOG INPUT 32
0.000
F35 Multiple Feeder Protection System
setting for the two transducers configured
× I
for the +IN and –IN inputs
BASE
6.3.5 IEC 61580 GOOSE ANALOG VALUES
6.3 METERING
6.3.4 FLEXELEMENTS
6
6-23
Advertisement
Table of Contents
