GE UR F35 Series Instruction Manual page 140

5.2 PRODUCT SETUP
• In Local Authentication mode, the Observer role does not have a password associated with it. In Remote Authentica-
tion mode the Observer role requires a password.
• The default password is "ChangeMe1#".
• Once the passwords are set, the Administrator with Supervisor approval can change the role associated password.
• In CyberSentry, password encryption is not supported.
d) SESSION SETTINGS

PATH: SETTINGS PRODUCT SETUP
 SESSION
 SETTINGS
The following session settings are available.
• SESSION LOCKOUT: This setting specifies the number of failed authentications (the default is three and the maxi-
mum is 99) before the device blocks subsequent authentication attempts for the lockout period. A value of zero means
lockout is disabled.
• SESSION LOCKOUT PERIOD: This setting specifies the period of time in minutes of a lockout period (the default is
three and the maximum is 9999). A value of 0 means that there is no lockout period.
e) RESTORE DEFAULTS
5

PATH: SETTINGS PRODUCT SETUP
 RESTORE DEFAULTS

• LOAD FACTORY DEFAULTS: This setting is used to reset all the settings, communication and security passwords. An
Administrator role is used to change this setting and a Supervisor role (if not disabled) approves it.
f) SUPERVISORY

PATH: SETTINGS PRODUCT SETUP
 SUPERVISORY

5-16
 
SECURITY SESSION SETTINGS
SESSION LOCKOUT:
3
SESSION LOCKOUT
MESSAGE
PERIOD: 3 min
 
SECURITY RESTORE DEFAULTS
LOAD FACTORY
DEFAULTS: No
 
SECURITY SUPERVISORY
LOCAL
AUTHENTICATION:Yes
BYPASS ACCESS:
MESSAGE
Disabled
LOCK RELAY:
MESSAGE
Disabled
FACTORY SERVICE:
MESSAGE
MODE: Disabled
 SELF TESTS
MESSAGE

SUPERVISOR ROLE:
MESSAGE
Disabled
SERIAL INACTIVITY
MESSAGE
TIMEOUT: 1 min
F35 Multiple Feeder Protection System
Range: 0 to 99
Range: 0 to 9999 minutes
Range: Yes, No
Range: Yes, No
Range: Enabled, Disabled
Range: Enabled, Disabled
Range: Enabled, Disabled
See below
Range: Enabled, Disabled
Range: 1 to 9999 minutes
5 SETTINGS
GE Multilin