GE UR F35 Series Instruction Manual page 149

5 SETTINGS
d) NETWORK
As outlined in the previous section, when using more than one Ethernet port, configure each to belong to a different net-
work or subnet using the IP addresses and mask.

PATH: SETTINGS PRODUCT SETUP
 NETWORK PORT 1

MESSAGE
MESSAGE
MESSAGE
 NETWORK PORT 2

MESSAGE
MESSAGE
MESSAGE
MESSAGE
 NETWORK PORT 3

MESSAGE
MESSAGE
MESSAGE
The
PRT1 (2, 3) GOOSE ENABLED
is available when the hardware has multiple ports (modules T, U, and V). It determines if ports 2 and 3
PRT2 REDUNDANCY
operate in redundant or independent mode. In non-redundant mode, port 2 and 3 operate independently with their own
MAC and IP address. In redundant mode, port 2 and 3 use the port 2 MAC and IP address, port 3 is in standby mode and
monitors its link to the Multilink switch, and when port 2 detects a problem with the link then communication switches to port
3 until the link returns. Reboot is required when using the redundancy option.
The IP addresses are used with the DNP, Modbus/TCP, IEC 61580, IEC 60870-5-104, TFTP, and HTTP protocols. Each
network protocol has a setting for the TCP/UDP port number. These settings are used only in advanced network configura-
tions and should normally be left at their default values, but may be changed if required (for example, to allow access to
multiple UR-series relays behind a router). By setting a different
series relay, the router can map the relays to the same external IP address. The client software (EnerVista UR Setup, for
example) must be configured to use the correct port number if these settings are used.
GE Multilin
 
COMMUNICATIONS
PRT1 IP ADDRESS:
127.0.0.1
PRT1 SUBNET IP MASK:
255.0.0.0
PRT1 GWY IP ADDRESS:
0.0.0.0
PRT1 GOOSE ENABLED:
Enabled
PRT2 IP ADDRESS:
127.0.0.1
PRT2 SUBNET IP MASK:
255.0.0.0
PRT2 GWY IP ADDRESS:
0.0.0.0
PRT2 REDUNDANCY:
No
PRT2 GOOSE ENABLED:
Enabled
PRT3 IP ADDRESS:
127.0.0.1
PRT3 SUBNET IP MASK:
255.0.0.0
PRT3 GWY IP ADDRESS:
0.0.0.0
PRT3 GOOSE ENABLED:
Enabled
setting provides the ability to disable/enable GOOSE transmission from the port.
F35 Multiple Feeder Protection System
NETWORK 1(3)
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Enabled, Disabled
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: No, Yes
Range: Enabled, Disabled
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Standard IPV4 address format
Range: Enabled, Disabled
for a given protocol on each UR-
TCP/UDP PORT NUMBER
5.2 PRODUCT SETUP
5
5-25