Using The Relay; Faceplate Keypad; Menu Navigation; Menu Hierarchy - GE UR F35 Series Instruction Manual

1.5 USING THE RELAY

1.5USING THE RELAY
1
Display messages are organized into pages under the following headings: actual values, settings, commands, and targets.
The MENU key navigates through these pages. Each heading page is divided further into logical subgroups.
The MESSAGE keys navigate through the subgroups. The VALUE keys increment or decrement numerical setting values
when in programming mode. These keys also scroll through alphanumeric values in the text edit mode. Alternatively, val-
ues can be entered with the numeric keypad.
The decimal key initiates and advances to the next character in text edit mode or enters a decimal point.
The HELP key can be pressed at any time for context-sensitive help messages.
The ENTER key stores altered setting values.
Press the MENU key to select a header display page (top-level menu). The header title appears momentarily followed by a
header display page menu item. Each press of the MENU key advances through the following main heading pages:
• Actual values
• Settings
• Commands
• Targets
• User displays (when enabled)
The setting and actual value messages are arranged hierarchically. The header display pages are indicated by double
scroll bar characters (), while sub-header pages are indicated by single scroll bar characters (). The header display
pages represent the highest level of the hierarchy and the sub-header display pages fall below this level. The MESSAGE
UP and DOWN keys move within a group of headers, sub-headers, setting values, or actual values. Continually pressing
the MESSAGE RIGHT key from a header display displays specific information for the header category. Conversely, contin-
ually pressing the MESSAGE LEFT key from a setting value or actual value display returns to the header display.
HIGHEST LEVEL
 SETTINGS
 PRODUCT SETUP
 SETTINGS
 SYSTEM SETUP
The relay is in the default "Not Programmed" state when it leaves the factory. When powered up successfully, the Trouble
LED is on and the In Service LED off. The relay in the "Not Programmed" state blocks signaling of any output relay. These
conditions remain until the relay is explicitly put in the "Programmed" state.
Select the menu message
RELAY SETTINGS:
Not Programmed
1. To put the relay in the "Programmed" state, press either of the VALUE keys once and then press ENTER. The face-
plate Trouble LED turns off and the In Service LED turns on.
1-18
 SECURITY


SETTINGS PRODUCT SETUP
F35 Multiple Feeder Protection System
LOWEST LEVEL (SETTING
VALUE)
ACCESS LEVEL:
Restricted
 
INSTALLATION RELAY SETTINGS
1 GETTING STARTED

1.5.1 FACEPLATE KEYPAD

1.5.2 MENU NAVIGATION

1.5.3 MENU HIERARCHY

1.5.4 RELAY ACTIVATION

GE Multilin