Table Of Contents - Emerson Rosemount 3051 Series Quick Start Manual

Quick Start Guide
NOTICE
This guide provides basic guidelines for Rosemount 3051 Transmitters. It does not provide instructions for
configuration, diagnostics, maintenance, service, troubleshooting, Explosion-Proof, Flame-Proof, or
intrinsically safe (I.S.) installations. Refer to the Rosemount 3051
This manual is also available electronically EmersonProcess.com/Rosemount.
Explosions could result in death or serious injury.
Installation of this transmitter in an explosive environment must be in accordance with the appropriate local,
national, and international standards, codes, and practices. Review the approvals section of the Rosemount
3051 Reference Manual

Before connecting a HART-based communicator in an explosive atmosphere, make sure the instruments
in the loop are installed in accordance with intrinsically safe or non-incendive field wiring practices.

In an Explosion-Proof/Flame-Proof installation, do not remove the transmitter covers when power is
applied to the unit.
Process leaks may cause harm or result in death.

To avoid process leaks, only use the o-ring designed to seal with the corresponding flange adapter.
Electrical shock can result in death or serious injury.

Avoid contact with the leads and the terminals. High voltage that may be present on leads can cause
electrical shock.
Conduit/cable entries

Unless marked, the conduit/cable entries in the transmitter housing use a
marked "M20" are M20
the same thread form. Only use plugs, adapters, glands, or conduit with a compatible thread form when
closing these entries.

When installing in a hazardous location, use only appropriately listed or Ex certified plugs, adapters, or
glands in cable/conduit entries.
Contents
Mount the transmitter. . . . . . . . . . . . . . . . 3
Consider housing rotation . . . . . . . . . . . . 7
Set the jumpers. . . . . . . . . . . . . . . . . . . . . . 8
Connect the wiring and power up . . . . . . 8
2
for any restrictions associated with a safe installation.
1.5 thread form. On devices with multiple conduit entries, all entries will have
Reference Manual
1
/
Verify configuration . . . . . . . . . . . . . . . . . 11
Trim the transmitter . . . . . . . . . . . . . . . . 14
Safety Instrumented Systems (SIS) . . . . 15
Product Certifications . . . . . . . . . . . . . . . 18
September 2016
for more instruction.
-14 NPT thread form. Entries
2