Table of Contents
Advertisement
SYSTEM CONFIGURATION
Entering Address setting page
Type in '@ and OK' to open Address Setting menu
INSTALLER SETUP
? + OK: Help Menu
@ + OK: Address Setting Menu
Multiple Monitor System Configuration
There are two way of connecting multiple monitors:
1. Daisy Chain - each monitor connects to the next monitor
2. Star Connection- all monitors connects to a central point
Up to 16 video monitors can be connected in a House system. Up to 4 monitors in each apartment for
Apartment systems. Each monitor in either system must be programmed with a 'User Code'- the
address
How to program the 'User Code' for Daisy Chain connection
All monitors must have same User Code '0' and programmed as Master/Slaves.
Program first monitor as Master, all others as Slave1, Slave2, Slave3.
If there are more than 3 Slave monitors in the system, program them with different user codes starting
with code 0, 1, 2, 3, 4 and so on as for Star connection . In addition to user code programming, last
monitor in the chain have to have DIP6 set On (end of line). Applicable Intercom Function for Master/
Slave programming: 'Inner Broadcast' and 'Inner Call'- all monitors ring at the same time. Intercom by
'NameList' requires different programming , same as for Star connection
How to program the 'User Code' for Star connection
All monitors must be connected to an additional hub- DBC4A distributor. One DBC4A can connect up
to a 4 video monitors. Each monitor in the system should be assigned with the unique 'User Code'
according the table and have DIP6 set 'On' in each monitor in the system.
There are two ways to program User Codes: via DIP-switches on the back of the monitor or via
'Ad d ress settings' menu. Choose 'Manual Input Address' option and type two digits and OK to confirm.
Allways start with user code 00 for House system and 01 for Apartments system. Range of user codes available
00-31. In addition to user code programming, program all monitors as 'Master'. Applicable Intercom
Function for such programming: 'Intercom by NameList' - to call to a specific monitor in the system
Power Saving Mode On/Off
By default the system is set to power saving mode, where only the first monitor in the system comes
O n with video when door station called. All other monitors will ring but without video. Video will be
transferred to the monitor which answers the doorbell call.
To switch the power saving mode off: (so all monitors ring with video), tick 'Slave Panel On' in the
'Address Setting' menu
_
123
-9-
Advertisement
Table of Contents
