Sagem myX-5 Technical Documentation Manual page 84

REMOVING / REPLACING THE BATTERY Proc Sheet 1 07
CONNECTOR
myX-3 & myX-5 1/2
4.56 Tools :
- A 0.6mm torx screwdriver
- Tweezers
4.57 Preliminary operation
1. Remove the back cover ( Proc sheet 0 01).
2. Remove the battery ( Proc sheet 0 02).
3. Remove the front cover ( Proc sheet 0 03).
4. Unscrew the six attachment screws on the electronic board.
5. Remove the assembly display , then the light guide keypad (Proc sheet 1 02 / 1 03)
6. Remove the electronic board.(Proc sheet 1 04)
4.58 Removal procedure :
1. Remove the battery connector (1) , using tweezers
4.59 Placement procedure :
1. Place the battery connector (1) in position in its housing , respecting the foolproof device.
4.60 Further operations :
1. Remove the electronic board on the assembly plate.(Proc sheet 1 04)
2. Replace the light guide keypad (Proc sheet 1.03)
3. Replace the assembly display (Proc sheet 1 02)
4. Position and tighten the six attachments screws with torx settings of 0,25 N.m.
5. Replace the front cover /battery / back cover (Proc sheet 0 01 / 0 02 / 0 03).
6. . Carry out the radio test (Test Sheet 06).
Ref. SCT U38 SSC DTS 009 – Index B - December 12 , 2002 Page 5-26