myX-3 & myX-5
4.31 Tools :
- A 0.6mm torx screwdriver
- gloves
•
This procedure must be performed by an technician provided with gloves , to avoid any risk of
pollution.
•
Contacts of display must be never touched.
4.32 Preliminary operation
1. Remove the back cover (
2. Remove the battery (
3. Remove the front cover (
4.33 Removal procedure :
1. On the electronic equipped module , unscrew the four attachment screws (5) .
2. Remove the assembly display (1) (2) (3).
1. Remove the display ( 3 ), of the support ( 2 ) by pushing it in its centre .
4.34 Placement procedure :
1. Replace the display (3) of the support (2),beginning with the bottom.
2. Replace the assembly display (1) (2) (3) on the electronic equipped module (4).
3. Position and tighten the four attachments screws with torx couple of 0,25 N.m.
4. Verify that there are no impurities on the display.
4.35 Further operations :
1. Replace the front cover
2. Replace the battery
(Proc sheet 0
3. Replace the back cover
4. Set the display parameters with OMM software (only for myX-5)
5. Carry out the radio test
.
Ref. SCT U38 SSC DTS 009 – Index B - December 12 , 2002
REMOVING / REPLACING THE DISPLAY
Proc sheet 0
01).
Proc sheet 0
02).
Proc sheet 0
03).
(Proc sheet 0
03).
02).
(Proc sheet 0
01).
(Test Sheet
06).
Proc Sheet 1 02
1/2
(Test Sheet 01)
Page 5-16