Table of Contents
Advertisement
Fluke 433/434
Users Manual
The Bar Graph display shows the percentage contribution of each of the components
related to the full signal. A signal without distortion should show a 1
fundamental) at 100 % while the others are at zero: in practice this will not occur because
there always is a certain amount of distortion resulting in higher harmonics.
A pure sinewave becomes distorted when higher frequency components are added to it.
Distortion is represented by the THD percentage. The display can also show the
percentage of the DC component and the K-factor. The K-factor is a number that
quantifies potential losses in transformers due to harmonic currents. Higher order
harmonics influence the K-factor more than low order harmonics.
The table below shows the number of Bar Graphs displayed simultaneously in one
screen:
All phase display
Single phase display
The left/right arrow keys are used to position the Cursor on a particular bar. The screen
header will show for that bar phase identifier, harmonic number, frequency, and phase
angle. If not all bars are shown on the screen, you can bring the next set within the
viewing area by moving the Cursor off the left or right end of the screen. The up/down
arrow keys are used for vertical zoom: 100 %, 50 %, 20 %, 10 %, or 5 % at full scale can
be selected. Using the SETUP key and function key F3 - FUNCTION PREF you can
choose harmonics display as a percentage of the fundamental voltage (%f) or the total of
harmonic voltages (%r). For detailed information see Chapter 18, FUNCTION
PREFerences.
Available function keys:
10-2
ENTER
1 ... 12
1 ... 50
Selection of harmonics type: Voltage, Current, or Real
F1
Power (Watt). Power harmonics can have positive and
negative polarity.
Selection of waveform set to be used: A (L1), B (L2), C
F2
(L3), N (neutral) or ALL
Access the table screen.
F3
Interharmonics display on/off (Fluke 434 only).
F4
Switch between HOLD and RUN of screen update.
F5
Switching from HOLD to RUN invokes a menu to select
immediate (NOW) or TIMED start time which allows you
to define start and duration of the measurement.
Harmonics
1 ... 6
1 ... 25
st
harmonic (= the
Harmonics & Interharmonics
Advertisement
Table of Contents
