Back Panel; Powering The Dolphin Homebase - Hand Held Products Dolphin 7600 Series User Manual

Back Panel

DC Power Jack
USB Port
Pivot Connector
This pivoting connector swivels 90 degrees. The default position is horizontal, with the connectors facing straight
out the back panel. The pivot connector stops in both the horizontal and vertical positions, with the connectors
facing out the bottom panel.
DC Power Jack
Connect the power cable to this power jack; see
USB Port
This USB port is full-speed (v1.1). Using the USB cable, you can connect the HomeBase to a USB-compliant device
to facilitate USB communication to and from the terminal. USB communication occurs through Microsoft ActiveSync
(v.4.1 or higher). For more information about ActiveSync setup, see

Powering the Dolphin HomeBase

The terminal requires 5 volts DC input for communication and battery charging; the power adapter on the power cable converts
the voltage from the power source to 5 volts DC. Only power adapter cables from Hand Held Products convert the voltage
appropriately.
The same power cable that ships with each terminal can be used
to power the HomeBase. This cable contains a plug adapter for
each geography (US, UK, EU, etc.).
1. Attach the appropriate plug adapter to the power adapter.
2. Plug the power cable into the power source.
3. Plug the connector into the DC power jack on the back panel.
The HomeBase is now powered.
When a terminal is properly seated in the terminal well, the
HomeBase powers the terminal, charges the terminal's main
battery pack, and launches ActiveSync (see
Communication on page 6-3).
Hand Held Products recommends that you leave the HomeBase connected to its power source at all times, so that it is always
ready to use.
Dolphin® 7600 Series User's Guide
Powering the Dolphin HomeBase
ActiveSync
Rev B
1/17/2007
Pivot Connector
on page 9-3.
ActiveSync Communication
1
on page 6-3.
Plug Adapter
Power Adapter
Power Cable
9 - 3