Wep Encryption Without 802.1X Authentication; Associating With Open Aps - Hand Held Products Dolphin 7600 Series User Manual

WEP Encryption Without 802.1X Authentication

1. Double-tap the Client icon on the command bar
2. On the Main Window (see page 7-3), tap the port and select Configure on the popup menu.
3. On the Wireless Networks Tab
(You may have to move the SSID from the list of Available Networks to the list of Configured Networks or add the SSID.)
4. On the Profile Info Tab
(This is necessary only if the SSID is not broadcasting its SSID.)
5. On the WEP Mgmt Tab
If the AP uses Shared authentication, also select Use key to authenticate.
If the AP uses Open authentication, leave it unselected.
6. Enter the WEP Key; see
7. On the main window, tap Client > Restart to restart the Client.
8. Wait as the Client connects.
9. When the connection is complete, the
Authenticated. However, the log file (see
recording this event.

Associating With Open APs

To associate with open APs means to set up the 802.11b/g radio without authentication or encryption.
1. Double-tap the Client icon on the command bar
2. On the Main Window (see page 7-3), tap on the port and select Configure on the popup menu.
3. On the Wireless Networks Tab
(You may have to move the SSID from the list of Available Networks to the list of Configured Networks or add the SSID.)
4. On the Profile Info Tab
5. Select default in the Authentication profile drop-down list.
6. On the WEP Mgmt Tab
7. Tap OK on the Wireless Networks tab.
8. On the Main Window (see page 7-3), tap Client > Restart to restart the client.
9. Wait as the Client connects.
10. When connection is complete, the
"Associated".
Note: If DHCP service is not enabled on the network, then a static IP address and subnet mask would need to be entered
manually.
7 - 16
(see page 7-7), select the SSID in the list of Configured Networks and tap Properties.
(see page 7-9), select Do active scan.
(see page 7-10), select Use key for data encryption.
Key on page 7-19. Tap OK.
Port Status Icon
Logging
(see page 7-7), select the SSID in the list of Configured Networks and tap Properties.
(see page 7-9), enter your AP's SSID in the Network Profile field.
(see page 7-10), make sure none of the options are selected. Tap OK,
Port Status Icon
Rev B
.
(see page 7-3) on the main window reads Associated instead of
on page 7-14) will read "Entered AUTHENTICATED state" when
.
(see page 7-3) turns yellow and the Status Bar (see page 7-5) reads
Dolphin® 7600 Series User's Guide