Certificates; Installing Certificates With The Meetinghouse Certificate Installer; Installing A Root Certificate - Hand Held Products Dolphin 7600 Series User Manual

Certificates

During configuration, you may have specified one or two certificates to use during the authentication process.
Certificate Requirements
The specified identity should match the Issued to field in the certificate and should be registered on the authentication server
that is used by the authenticator (i.e., a RADIUS server). In addition, your certificate must be valid on the authentication server.
This requirement depends on the authentication server and generally means that the authentication server must know the issuer
of your certificate as a trusted Certificate Authority (CA).
If the selected certificate does require a password or pass phrase to decode the private key, enter the password or pass phrase
in the Certificate Pass Phrase field in the Meetinghouse Certificate Installer. This value will be encrypted when the configuration
is saved. However, on some systems, there may not be a certificate.
Note: Client or CA certificates can be imported from *.cer (same as *.der), *.p7b, or *.pfx files.

Installing Certificates with the Meetinghouse Certificate Installer

CertAdd is a separate utility that allows certificates to be selected and installed on the device for the Client. This method ensures
that the certificate is recognized by the Client.
1. Download the certificate file to the device; see
2. Tap to Start > Programs > Meetinghouse Certificate Installer.
3. Navigate to the certificate location. Tap and hold on a certificate in the list.
4. Tap OK on the popup message and the certificate is loaded into the correct certificate store.
5. Tap the Server Tab (see page 7-15) and verify that the certificate appears in the Certificate issuer must be drop-down list.
6. To verify that the operating system recognizes this certificate, see

Installing a Root Certificate

This method ensures that the certificate is recognized by the operating system. Sometimes, if a certificate is not functioning
properly, it can mean that the operating system doesn't recognize it even if the Client does. Follow these steps to verify that the
operating system recognizes the certificate.
1. Save the certificate to the device. If no error appears when you save the certificate, it was most likely saved to the device.
Note: To make sure that the certificate persists through cold boots, install the certificate to the \IPSM folder.
2. To verify that the certificate is recognized by the operating system, tap Start > Settings > Control Panel > Certificates
.
3. This list displays all the certificates recognized by the operating system. If your certificate appears in this list, the operating
system recognizes it.
4. Scroll through the list until you see the certificate you installed. After you have identified your certificate in the list, tap OK to
close.
5. To use the certificate in a network profile, tap the Client icon in the command bar
Dolphin® 7600 Series User's Guide
Installing a Root Certificate
Installing a Root Certificate
Rev B
on page 7-17.
on page
.
7-17.
7 - 17