Activating The Engine; Decoding - Hand Held Products Dolphin 7600 Series User Manual

Activating the Engine

When a scanning application is open, press the Scan key
side buttons (see Side Button
default.
Using Demos
Dolphin Demos are software utilities loaded on all Dolphin terminals that demonstrate the advanced features of the terminal.
There are two Demos feature the image engine: Image Demo and Scan Demo.
To access these demos, tap Start > Programs > Demos,
• Select Scan Demo to verify decoding, or
• Select Image Demo to verify imaging.
For more information about Demos, refer to the Dolphin Demos User's Guide, which is available for download from
www.handheld.com.
LEDs
The LEDs in the center of both keyboards (for location, see
Scan LED
Decode LED

Decoding

The Dolphin terminal supports two types of image decoding: full-area imaging and Advanced Linear Decoding (ALD).
Full-area Imaging
Full-area imaging means that the Dolphin terminal support omni-directional aiming, which means that a positive
read can be obtained from many positions. For details, see
ALD
ALD provides fast reading of linear (1D) and stacked linear bar codes (PDF417). For the best read, the aiming
pattern should be centered horizontally across the bar code. When ALD is enabled, the reader does not read matrix
or postal codes.
To Decode a Bar Code
1. Tap Start > Programs > Demos > Scan Demo.
2. Position the Dolphin terminal over one of the sample bar codes on page 5-4.
A range of 4–10 inches (10–25 cm) from the bar code is recommended.
3. Project the aiming brackets by pressing and holding the Scan key. The Scan LED lights red
4. Center the aimer crosshair over the bar code. The aiming beam should be oriented in line with the bar code to achieve
optimal decoding; Omni-Directional Scanning
5. When the bar code is successfully decoded, the decode LED lights green and the terminal beeps.
Dolphin® 7600 Series User's Guide
on page 3-5), which are programmed to activate the image engine in a scanning application by
The LED on the right lights red when you press the scan trigger in scanning applications.
The LED on the left lights green when a scanned bar code is successfully decoded.
Positions, page 5-4
SCAN
to activate the image engine. You can also press one of the
LEDs on page 4-1) light when using the image engine.
Omni-Directional Scanning Positions
Rev B
1/17/2007
on page 5-4.
.
5 - 3