Dew Sensor Power; Uninstallation; Specifications - Danfoss CF-RC Instruction

Instruction
6.1.7 Dew sensor power
Menu  Setup  Service  Dew sensor power: Activate Dew sensor power to configure
a dew sensor to be powered by CF-MC Master Controller (only output 5 can be used).
Status of output 5 is displayed:
• If output 5 is in use, Remote Controller tells you where.
• If nothing is installed on output 5, Sensor not detected is displayed.
• If a dew sensor is installed on output 5, the power status is displayed as ON or OFF.
Select Change to change the power status.
• Confirm the changes with Yes or discard the changes with No.

7. Uninstallation

Resetting CF-RC Remote Controller (fig. 1)
• At the same time, activate the Soft key 1 , the soft key 2  and the down selector .
• Remote Controller requests confirmation before resetting. Confirmation with Yes resets
Remote Controller.
• Confirm reset with Yes. Remote Controller is now ready for installation to a Master
Controller.
Note: Please see Master Controller instruction for further details.

8. Specifications

Cable length (power supply)
Transmission frequency
Transmission range in buildings (up to)
Number of Repeater Units in a chain (up to)
Transmission power
Supply voltage
Ambient temperature
IP class
16 Danfoss Heating Solutions
CF-RC Remote Controller
VIUHM602
1.8 m
868.42 MHz
30 m
3
< 1 mW
230 VAC
0-50°C
21
© Danfoss 03/2011