Hard Drive Cage - HP ProLiant ML370 Maintenance And Service Manual

Hard Drive Cage

To remove the hard drive cage:
1. Power down and remove power from the server. Refer to "Powering Down the Server" in
this chapter.
2. Remove the tower or rack front bezel. Refer to "Front Bezel" or "Rack Bezel" in this
chapter.
3. Remove the access panel. Refer to "Access Panel" in this chapter.
4. Remove all hard drives and blanks. Refer to "Hard Drive Blank" and "Hot-Plug SCSI
Hard Drive" in this chapter.
5. Disconnect the point-to-point SCSI cable from the SCSI hard drive backplane (1).
6. Disconnect the power cable from the SCSI hard drive backplane (2).
NOTE: The center wall is removed from Figure 2-24 for clarity.
Figure 2-24: Disconnecting the SCSI and power cables
7. Remove the four T-15 screws securing the hard drive cage to the chassis (1).
8. Slide the hard drive cage out through the front of the chassis (2).
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
Removal and Replacement Procedures
2-27