HP ProLiant ML370 Maintenance And Service Manual page 38

For additional information, refer to the HP ProLiant ML370 Generation 3 Server Setup and
Installation Guide.
All fans are identical. This procedure can be used for any one of the six fan positions. To
remove the fans:
1. Unlock and open the front bezel (tower server only).
IMPORTANT: You must unlock the tower bezel before removing the access panel. Refer to "Front
Bezel" in this chapter.
2. Remove the access panel. Refer to "Access Panel" in this chapter.
3. Grasp the plastic handle at the top of the fan and pull upward (1).
4. Lift the hot-plug fan out of the fan cage (2).
Figure 2-21: Removing a system fan
To replace the hot-plug system fan, slide it into a fan cage slot and press down until the fan is
seated securely. Be sure that the LED on the fan is green indicating that it is working.
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
Removal and Replacement Procedures
2-23