Removing The Server From The Rack - HP ProLiant ML370 Maintenance And Service Manual

Removing the Server from the Rack

You need to remove the server from the rack when performing non-hot-plug removal and
replacement procedures. To remove the server from the rack:
1. Power down the server. Refer to "Powering Down the Server" in this chapter.
2. Disconnect all AC power cords from the AC outlets and then from the server.
Figure 2-5: Unlocking the cable management arm hinge
Figure 2-6: Swinging open the cable management arm to access
the cables
HP ProLiant ML370 Generation 3 Server Maintenance and Service Guide
Removal and Replacement Procedures
2-9