Icom iC-M605 Instruction Manual page 22

4
MENU SCREEN
■ Construction (Continued)
Noise Cancel
• RX Set the reduction level of
the Noise Cancel function.
• TX Turn the Noise Cancel
function for the transmit
signal ON or OFF.
Power SW from Sub Unit
• All Units When you turn OFF the
command head, the
transceiver is turned OFF
at the same time.
• Own Unit The transceiver is not
turned OFF even if you
turned OFF the command
microphone.
• DSC Log (p. 56)
Received Call Log Displays the received
call log.
Transmitted Call
Displays the transmitted
call log.
Log
• Radio Settings (p. 86)
Scan Type* 4 Select a Scan Type from
Normal Scan or Priority
Scan.
Scan Timer* 4 Turn the Scan Timer
function ON or OFF.
Dual/Tri-Watch* 4 Select the Dualwatch or
Tri-watch function.
Channel Group Select a channel group.
Call Channel Set the Call channel.
* 1 May not be displayed, depending on the version.
* 2 Not displayed, when valid GPS data is received.
12 * 3 Displayed only when the voice scrambler unit is installed.
WX Alert* 1 Turn the Weather Alert
function ON or OFF.
Voice Scrambler* 3 Set the Voice Scrambler
code.
Voice Record
Select whether or not to
automatically record the
voice audio.
FAV Settings Set the Favorite channel
settings.
FAV on MIC Turn the FAV on MIC
function ON or OFF.
• DSC Settings (p. 58)
Position Input* 2 Enter your position.
Individual ID Enter an Individual ID.
Group ID Enter a Group ID.
Auto ACK Select whether or not to
automatically transmit an
Acknowledgement after
receiving each type of call.
CH Auto Switch Select whether or to
automatically select the
channel that the DSC
call is received on, when
received.
DSC Data Output Select a DSC Data Output
option.
Alarm Status
• Safety Turn the Alarm Status for
Safety ON or OFF.
• Routine Turn the Alarm Status for
Routine ON or OFF.
• Warning Turn the Alarm Status for
Warning ON or OFF.
* 4 Not usable in Dutch version.
• Self-Terminate Turn the Alarm Status for
Self-Terminate ON or OFF.
• Discrete Turn the Alarm Status for
Discrete ON or OFF.
CH 70 SQL Level
Select the Channel 70
squelch level.
Self Check Test Starts the self check Test.
Procedure* 1 Select the Single task
mode or Multiple task
mode.
• AIS Settings (p. 78)
North Up/COG Up Select the display type
for AIS plotter.
CPA/TCPA Edit the alarm settings for
AIS receiver.
ID Blocking Enter the vessel's or your
transponder ID to block.
• NMEA Settings (p. 89)
NMEA0183
• Port 1, Port 2
Select the data transfer
speed to receive and
transmit data from
external devices.
NMEA2000
• GPS, AIS Select the sensors in
NMEA 2000 network
which sends GPS or AIS
data to the transceiver.
• Radio Information (p. 91)
Displays your transceiver' s Serial number,
software version, GPS module version, and
so on.