Tail Type Setting - GRAUPNER MX-10 HOTT Programming Manual

Notes:
• During the programming process it is important
to ensure that any internal-combustion engine or
electric motor cannot start running accidentally.
The safe option is always to disconnect the fuel
supply or the fl ight battery.
Tail type
The tail confi guration is chosen with the supplied jumper
in the contact strip „MIX" on the front of the transmitter.
Select the positioning of the jumpers to match your
model type
„normal": The elevator and rudder is operated by
only one servo.
The jumper connects the two middle pins
„NO MIX".
„2 Aileron":
option is for models with 1 or 2 ailerons.
The at the channel 5 connected servo
runs parallel to the servo on channel 2
The Aileron trim affects both servos.
The jumper connects the two left pins
„AILE".
„Delta/FW": The aileron and elevator rudder is
controlled by one servo per wing half,
connected on channel 2 and 3. The cou-
pling function for the aileron and elevator
control is performed automatically by the
transmitter mixer.
The jumper connects the two right pins
„DELTA".
„V-Tail": The elevator and rudder functions are
operated by two control surfaces set in a
V-shape, each controlled by a separate
servo, connected to channel 2 and 3. The
two-way coupling function for the rudder
and elevator control systems is automati-
cally carried out by the transmitter soft-
ware.
Two jumpers connect the two left „AILE"
This
and two right „DELTA" pins.
Due to the different installation of the servos and push-
rods the initially servo direction of certain servos may
be wrong. The following table provides guidance for
remedial action.
Servo with
Model
wrong
type
rotating direction
V-Tail Rudder and
elevator wrong
direction
Rudder correct,
elevator wrong
direction
Elevator correct,
rudder wrong
direction
Delta, Elevator and Ail
Flying wrong direction
wing
Elevator correct, Ail
wrong direction
Ail correct, Elevator
wrong direction
Program description: base settings - fi xed-wing model
Solution
servo reverse for
channel 3 + 4 in the bar
„Servo reverse"
change servo 3 + 4 at
the receiver
servo reverse for
channel 3 + 4 in the bar
„Servo reverse" AND
change at the receiver
servo reverse for
channel 2 + 3 in the bar
„Servo reverse"
servo reverse for
channel 2 + 3 in the bar
„Servo reverse" AND
change at the receiver
change servo 2 + 3 at
the receiver
105