Configuring Cfd Functions; Configuration Prerequisites; Configuring Cc On Meps - HP 5130 EI Series Configuration Manual

Step
1. Enter system view.
2. Configure MIP
auto-generation rules.

Configuring CFD functions

Configuration prerequisites

Complete basic CFD settings.

Configuring CC on MEPs

Configure CC before configuring other CFD functions. After the CC function is configured, MEPs in an
MA can periodically send CCM frames to maintain connectivity. When the lifetime of a CCM frame
expires, the link to the sending MEP is considered disconnected. When setting the CCM interval, use the
settings described in
Table 5 CCM interval field encoding
CCM interval field
1
2
3
4
5
6
7
Follow these guidelines when you configure CC on a MEP:
Configure the same CCM interval field value for all MEPs in the same MA.
•
The switch does not support a CCM interval field value in the range of 1 to 3. If you configure a
•
CCM interval field value of 1, 2, or 3, the value of 4 takes effect.
Configurations in Ethernet interface view take effect only on the current interface.
•
• Configurations in aggregate interface view take effect on the aggregate interface and all its
member ports.
Configurations on a member port take effect only when the member port leaves the aggregation
•
group.
To configure CC on a MEP:
Command
system-view
cfd mip-rule { default | explicit }
service-instance instance-id
Table 5.
Transmission interval
10/3 milliseconds
10 milliseconds
100 milliseconds
1 second
10 seconds
60 seconds
600 seconds
Maximum CCM lifetime
35/3 milliseconds
35 milliseconds
350 milliseconds
3.5 seconds
35 seconds
210 seconds
2100 seconds
21
Remarks
N/A
By default, no rules for generating
MIPs are configured, and the
system does not automatically
create any MIP.