Safe Stop Of Fc 302; General Warning - Danfoss MCO 305 Operating Instructions Manual

Safety Instructions and Gen... MCO 305 Operating Instructions

2.5 Safe Stop of FC 302

2 2
The FC 302 can perform the Designated Safety Function
Uncontrolled Stopping by removal of power (as defined by
IEC 61800-5-2) or Stop Category 0 (as defined in EN
60204-1). It is designed and approved suitable for the
requirements of Safety Category 3 according to EN
954/PLd according to ISO 13849-1. This functionality is
called Safe Stop.
In order to install and use the Safe Stop function in
accordance with the requirements of Safety Category 3
according to EN 954-1/PLd according to ISO 13849-1, the
related information and instructions of the VLT
AutomationDrive Design Guide MG.33.BX.YY must be
followed! The information and instructions of Operating
Instructions are not sufficient for a correct and safe use of
the Safe Stop functionality.

2.6 General Warning

WARNING
Touching the electrical parts may be fatal – even after the
equipment has been disconnected from mains. Also make
sure that all voltage inputs have been disconnected, such
as load-sharing (linkage of DC intermediate circuit), as well
as the motor connection for kinetic back-up. Using VLT
AutomationDrive (at and below 7.5kW):
wait at least xx minutes.
xx = The waiting time using the VLT AutomationDrive is
different for different sizes: Please see period of waiting
time xx in the VLT AutomationDrive Operating Instructions,
MG.33.AX.YY.
®
6 MG.33.K3.02 - VLT is a registered Danfoss trademark