Aposs Software Messages - Danfoss MCO 305 Operating Instructions Manual

Troubleshooting

7.2 APOSS Software Messages

The APOSS software messages are arranged in alphabetical
order. Letters following a % sign represent variables which
can be used in plain text at the corresponding locations.
Compilation error(s): program not saved!
A file is always compiled first and then saved. If you want
to save the program, for example in the menu Controller →
Save program and a syntax error is found during
compilation this message will be displayed.
Start the → Syntax Check in the menu Development, correct
the syntax error and then save the program.
Connection to ... already exists . . .
7 7
Connection to %d already exists [%s] - change to Window?
When opening a new window, or when trying to connect
a window with a controller that is already linked to a
window.
Yes: The controller is disconnected from the old window
and linked to the new window.
No: The controller stays connected to the old window.
The new window is not linked to a controller.
Connector pin is not valid
Connector %d pin %d is not valid in line %d column %d
An illegal combination or a pin number which cannot be
set is used with the OUT command.
Controller is executing a program or command!
When the controller is executing a command or program it
is not available for additional commands. You have to
Break the new command and re-start it once the previous
command has been completely.
Error in array part of file
When re-saving a configuration (e.g. Controller →
Parameters → Restore from file) the computer recognizes
that the data in the array area is formatted incorrectly.
In order to be able to save a file, the following conditions
must be fulfilled:
- Identical software versions,
- same configuration (e.g. same number of axes),
- in the case that arrays have already been
inputted, these must match the ones that are to
be saved in terms of type and size.
34
MCO 305 Operating Instructions
Error in axis parameter part of file
When re-saving a configuration (e.g. Controller →
Parameters → Restore from file) the computer recognizes
that the data in the area of the axis parameters is
formatted incorrectly. The parameter number and the
sequence must be correct and numbering must be
continuous.
In order to be able to save a file, the following conditions
must be fulfilled:
-
-
Error in global parameter part of file
When re-saving a configuration (e.g. Controller →
Parameters→ Restore from file) the computer recognizes
that the data in the area of the global parameters is
formatted incorrectly.
In order to be able to save a file, the following conditions
must be fulfilled:
-
-
Lost connection to ...
If the VLT AutomationDrive is turned off or the plug is
pulled, etc. the window is disconnected from the VLT
AutomationDrive and the lost connection is registered.
Timeout: no reply from FC
The VLT AutomationDrive does not answer; check the
connection.
®
MG.33.K3.02 - VLT is a registered Danfoss trademark
Identical software versions, that provides same
number and order of the parameters,
same configuration (e.g. same number of axes).
Identical software versions, that provides same
number and order of the parameters,
same configuration (e.g. same number of axes).