How To Install The Application; Download Application Program And Configuration; Backup And Restore - Danfoss MCO 305 Operating Instructions Manual

How to Install the Applicat...

5 How to Install the Application

5.1 Download Application Program and
Configuration
Follow these steps to create and download MCO 305
program and configuration using MCT 10 and APOSS
5 5
1. Open MCT 10.
2. Open the folder "Project – Drive – MCO 305 –
programs".
3. Right click in the right hand view and select:
a. "Import program file" if using an existing program
"outside" the project file or,
b. "New MCO 305 program" when writing a new
program. Right click the program file and double
click or right click and select "Edit". Program
editor will open.
4. Repeat step 3 if more programs are required.
5. One program must be set as Autostart program:
Right click the program file and select "Set as
Autostart".
6. Open the folder "Project – Drive – MCO 305 –
Arrays".
7. Right click on the file and select "Import" or
"Edit".
8. Right click on the MCO 305 folder in the tree
structure in the left-hand view of MCT 10 and
select "Write to drive".
9. "Write MCO 305 Program Source Files to the
Drive" must be ticked if it should be possible to
read the program from the frequency converter.

5.2 Backup and Restore

All parameters and MCO 305 data can be read out and
stored in an MCT 10 project and thus restored to the
frequency converter.
NOTE
MCO 305 programs can only be read-out when they have
be downloaded including source code!
Use the following steps to back-up parameters and data by
PC:
1. Go on-line with the drive via the Network folder.
2. Right click on the drive folder and select copy.
"Include programs" must be ticked.
24
MCO 305 Operating Instructions
3.
4.
Now parameters and MCO 305 data is stored in the project
file, restore by the following steps:
1.
2.
3.
Now both parameters and MCO 305 data is restored in the
drive.
Backup and Restore via LCP
Both parameters and MCO 305 data can be stored in the
LCP and thus restored from the LCP to another frequency
converter.
Use the following steps to back-up parameters data in the
LCP:
1.
2.
Now parameters and MCO 305 data is stored in the LCP,
restore by the following steps:
1.
2.
Now both parameters and MCO 305 data are restored in
the frequency converter.
®
MG.33.K3.02 - VLT is a registered Danfoss trademark
When copy is completed, paste the drive in-to a
project folder.
Save the project.
Open the project file with MCT 10 Set-up
Software.
Go on-line with the drive via the Network folder.
Open the project folder, Right click on the drive
folder and select "Write to drive".
Select "All to LCP" [1] in 0-50 LCP Copy.
Select "File from MCO to LCP"
Copy.
Select "All from LCP" [2] in 0-50 LCP Copy.
Select "File from LCP to MCO"
Copy.
[4] in 0-50 LCP
[5] in 0-50 LCP