Introduction; Available Literature For Vlt Automationdrive, Mco 305 And Mct 10 Motion; Control Tool; Symbols And Conventions - Danfoss MCO 305 Operating Instructions Manual

Introduction

1 Introduction
1.1 Available Literature for VLT
AutomationDrive, MCO 305 and MCT 10
Motion Control Tool
- The MCO 305 Design Guide entails all technical
information about the option board and
customer design and applications.
- The MCO 305 Command Reference completes the
MCO 305 Design Guide with detailed description
of all commands available for programming MCO
305.
- The VLT AutomationDrive Operating Instructions
provide the necessary information for getting the
frequency converter up and running.
- The VLT AutomationDrive Programming Guide
provides complete descriptions of all parameters
in the frequency converter.
- The VLT AutomationDrive Design Guide entails all
technical information about the frequency
converter and customer design and applications.
- The VLT AutomationDrive Profibus Operating
Instructions provide the information required for
controlling, monitoring and programming the
drive via a Profibus fieldbus.
- The VLT AutomationDrive DeviceNet Operating
Instructions provide the information required for
controlling, monitoring and programming the
drive via a DeviceNet fieldbus.
- The VLT AutomationDrive MCT- 10 Operating
Instructions provide information for installation
and use of the software on a PC.
Danfoss Drives technical literature is also available online
at www.danfoss.com/drives.

1.2 Symbols and Conventions

Symbols
The following symbols are used in this manual.
WARNING
Indicates a potentially hazardous situation which, if not
avoided, could result in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury. It may
also be used to alert against unsafe practices.
MCO 305 Operating Instructions
CAUTION
Indicates a situation that may result in equipment or
property-damage-only accidents.
NOTE
Indicates highlighted information that should be regarded
with attention to avoid mistakes or operate equipment at
less than optimal performance.
Approvals
Conventions
The information in this manual follows the system and
uses the typographical features described below to the
greatest extent possible:
Menus and Functions
Menus and functions are printed italics, for
example:Controller
Commands and Parameters
Commands and parameter names are written in capitals,
for example: AXEND and KPROP; Parameters are printed in
italics, for example: Proportional factor.
Parameter Options
Values for use to select the parameter options are written
in brackets, e.g. [3].
Keys
The names of keys and function keys are printed in
brackets, for example the control key [Cntl] key, or just
[Cntl], the [Esc] key or the [F1] key.
®
MG.33.K3.02 - VLT is a registered Danfoss trademark
→ Parameters.
1 1
3