GE MDS SD Series Technical Manual page 58

•
Dlink TCP Port
dress for Ethernet-based DLINK communication is given by the radio's IP address (from
the screen) and the port number specified here.
Overview
Advanced Settings
•
Soft-Carrier Dekey (ms)
ing signal before actually dropping the transmitter's carrier. The default setting is
may be set to any value up to
fault setting. A possible exception is when the transceiver is inter-working with certain
early-generation MDS radio equipment.
NOTE SCD in intended for use ONLY in x710 or Transparent modes when interacting with
legacy equipment. To prevent delayed key downs when sending packetized data, SCD
should be left at the default of 0 when operating in Packet or Packet with MAC modes
•
RX Time-Out Enable
against a receiver which fails to receive data for a period exceeding the RX time-out de-
lay setting (see below). When the time is exceeded, an alarm is issued. The alarm may be
used to signal switchover to an alternate unit in redundant systems. The RX time-out is
cleared when the radio receives a new Carrier Detect signal. The default selection is
(no RX time limit).
•
RX Time-Out Delay (min)
nals have been received. The default setting is
•
TX Time-Out Status
a transmitter which remains keyed for a period exceeding the TX Time-Out Delay setting
(see below). When this time is exceeded, the transmitter is taken offline, preventing dis-
ruption of the wireless network. The TX time-out is cleared when the keying source goes
48
— This setting specifies the TCP port for DLINK communication. The ad-
— Specifies how long (in ms) to wait after the removal of the key-
ms. In most cases, no change is required from the de-
255
— Enables or disables the RX time-out function. RX time-out protects
— Sets the time delay, after which an alarm is issued when no sig-
— Enables or disables the TX Time-Out function. This protects against
SD Series Technical Manual
minutes.
0
MDS 05-4846A01, Rev. I
, but it
0
OFF