GE MDS SD Series Technical Manual page 47

Task
If you wish to...
Category
Configure the IP settings (Static IP Address,
Static IP Netmask, Static Default Gateway,
DHCP enable/disable, Virtual Radio Channels–
VRCs)
Configure Ethernet Bridging, enable/disable
Bridge Filtering
Configure the IP Payload settings
(Enable/disable port, set mode, Local IP Port,
Destination IP Address, Destination IP Port)
Configure COM1 settings (Startup mode, Data
Baud Rate, Data format, Virtual Radio
Channels–VRCs)
Configure COM2 settings (Mode, Baud Rate,
Format, Buffer on/off, Device Type, Virtual
Radio Channels–VRCs)
View Radio Performance data (Power Output,
Signal-to-Noise Ratio, Received Signal
Strength, DC Input voltage, operating
temperature)
Perform radio tests (Radio Keying, show
Spectrum Graph, run RTU Simulator)
View Bootloader version information, Active
Firmware Image, Firmware Version level
Locally Reprogram the Transceiver via TFTP
transfer
Broadcast Remote Configuration settings to all
radios in the network
Work with Configuration Files...
–Restore Factory default configuration
–Save/restore user configuration
–View/restore key configuration parameters
–Save/load key configuration parameters
MDS 05-4864A01, Rev. I
Table 11. Device Manager Quick Reference
using file transfer (TFTP)
SD Series Technical Manual
Refer to this
Screen/Section
Configuration>>
Communication Ports>>
IP Configuration, Page 64
Configuration>>
Features>>
Bridge Configuration, Page
50
Configuration>>
Features>>IP Payload 1, 2,
3, Page 53
Configuration>>
Communication Ports>>
COM1 Port Settings, Page
62
Configuration>>
Communication Ports>>
COM2 Port Settings, Page
63
Maintenance & Status>>
Performance>>
Radio Performance, Page
71
Maintenance & Status>>
Radio Test, Page 74
Maintenance & Status>>
Firmware
Utilities>>Version
Information, Page 77
Maintenance & Status>>
Firmware Utilities>>TFTP
Reprogramming, Page 78
Setup Wizards>>Remote
Management, Page 28
Maintenance & Status>>
TFTP Configuration File,
Page 81
37