GE MDS SD Series Technical Manual page 89

•
Channel Usage
•
Packet Data Size
size is .
40
• — Used to specify the number of times a transmission is repeated when a
Retry Count
packet is not received correctly. Default setting is
•
Reprogram Block Size
setting is .
512
• — When enabled, causes the transceiver to automatically reboot after a
Auto-Reboot
firmware image upgrade. If disabled, the newly loaded image will not become valid until
the transceiver is rebooted manually.
•
Download Delay
begins. Typically, it is set to
lecting one of the extended delay times from the drop-down box (
)
None
Verify Image
This screen is used to verify the integrity of an image stored in flash memory. You may wish to
verify an image after reprogramming or as part of a troubleshooting sequence.
• — Click this button to verify the firmware image selected in the drop-down box at
Verify
the top of the screen. The available selections from the box are:
, , and
1 Image 2
MDS 05-4864A01, Rev. I
— Set to either intrusive or passive as desired.
— Used to specify the size of the reprogramming data packets. Default
— Sets the overall block size (in bytes) of each data packet. Default
— This field can be used to introduce a time delay when reprogramming
Extended Delay-1
.
Inactive image
SD Series Technical Manual
.
3
, but may be increased incrementally by se-
Current active image
Extended Delay-1, 2, 3,
,
Image
79